Customers who bought this item also bought
The OE S2000 rear wheel hubs are unfortunately a weak point when combined with track use and meaty tire setups. The primary failure point is from the lightening cut-outs on the backside of an already thin hub flange. Karcepts S2000 Rear Hubs are filled in solid and built with an increased flange thickness. Rotor retention screw holes have also been eliminated. These 3 simple geometric adjustments have reduced stresses by two-fold over the OE units. Along with design optimization, Karcepts hubs are machined from chromoly steel and heat treated for an even greater endurance limit. Direct replacement for Honda 42210-S2A-000 Solid 8.75mm thick hub flange (9% thicker than OE) CNC turned from billet chromoly steel Oil quenched and tempered for improved fatigue strength Precision ground bearing journals Maintains OE rotor-centric attributes and offset Fits all 00-09 Honda S2000 without modification Wheel studs not included Sold in pairs
This is our preferred front lower ball joint. Helps correct Roll center along with additional front camber. We've ran "the other" extended ball joints and have found too them to add too much leverage on the lower spindle mounts. This leads to the spindle failing and gets very sketchy. We have yet to see a spindle failure since switching to these.
