Search

Karcepts S2000 Rear Billet hubs, PAIR

SKU: karceptshubs
$405.00
The OE S2000 rear wheel hubs are unfortunately a weak point when combined with track use and meaty tire setups. The primary failure point is from the lightening cut-outs on the backside of an already thin hub flange. Karcepts S2000 Rear Hubs are filled in solid and built with an increased flange thickness. Rotor retention screw holes have also been eliminated. These 3 simple geometric adjustments have reduced stresses by two-fold over the OE units. Along with design optimization, Karcepts hubs are machined from chromoly steel and heat treated for an even greater endurance limit. Direct replacement for Honda 42210-S2A-000 Solid 8.75mm thick hub flange (9% thicker than OE) CNC turned from billet chromoly steel Oil quenched and tempered for improved fatigue strength Precision ground bearing journals Maintains OE rotor-centric attributes and offset Fits all 00-09 Honda S2000 without modification Wheel studs not included Sold in pairs
+ -
*
*
*
*
Customers who bought this item also bought

Timken S2000 Wheel bearing, each

S2000 OE replacement wheel bearings. Sold individually. TIMKEN 510050
$45.00

ARP Honda M12x2.85inch Wheel Studs, 5Pack

ARP 80-00 Honda M12x2.85inch 5 Wheel Stud Kit Replacing your wheel bearings? Might as well install some fresh studs at the same time. Sold in packs of 5.
$45.00

Torque Solution S2000 Axle Half Shaft Spacers

Is your S2000 starting to shake under power or even light load? What about when cornering? This is the quick and easy fix. Axle spacers will push the axle cup further inwards giving it a nice fresh surface. Install time of 10-20 minutes and get back to enjoying that smooth Vtec again.
$92.95

Karcepts S2000 Front Sway Bar kit, 1.25in Bar

The only sway bar you need for your S2000. In almost every case, the S2000 needs a stiffer front sway bar.
$995.00